2. FEATURES
1. Latest LED technology.
2. Minimal heat output.
3. Three preset programs
FAST : Full power output.
PULSE : 0.5 second intermittent output.
RAMP : Soft Start.
4. Timer
The Led 55N has a fixed timer. The unit will cure for a total of 20 seconds. At 10 seconds the light will
beep indicating that you have reached the 10 second time mark. At 20 seconds the light will beep
again and automatically stop the curing process.
5. Built-in light intensity sensor
The led 55N base has the a built in light intensity sensor on the charging base. This will allow the end
user to verify if there is sufficient power to cure materials. To verify light intensity you must use a LED
light radiometer.
6. Sleeping Mode
The LED 55N will be in “trickle” charging mode after 3 min of non - use. Trickle charging mode only
applies if the handpiece is placed on the charging base. If left off of charging base the light will be in sleep
mode.
7. Auto Memory
LED 55N will remain in previous setting, including the curing time and the curing program.
8. Cordless
The LED 55N comes with two re-chargable lithium ion Batteries. once one battery is drained you may
switch to the other battery that will be fullly charged if it has been placed on the charging base.
9. Low Battery / Over Heat indicator
The low battery indicator light will illuminate “red” when the battery
does not have sufficiant power to operate the light. The over heat light
will illuminate “yellow” if the handpiece has over heated. If the light over
heats allow the light to rest for 10 min. When the light is illuminated “green”
the light has sufficient power to cure.
2