5.5 START AND STOP OF WINDING CYCLE (PROGRAM)
Winding cycle is actuated by pressing START-button (4), or foot pedal.
There is a possibility to start program from each step. Required step is set up by the buttons
, or numeric keyboard.
STOP-button (5) interrupts the winding cycle. It is the priority button, what means, that the cycle
interruption at incorrect time (while deceleration), may cause inaccurate stopping and
positioning of the spindle.
Cycle interruption at the step "Winding" allows almost all corrections and adjustments.
Repeated cycle start by START-button or foot pedal activates step, where the program
interruption has been done, automatically.
Step types SHIFT, JUMP and PAUSE do not allow any corrections or adjustments
during interruption.
5.6 FOOT PEDAL
Winding machine may be equiped by following types of foot pedals:
Double foot pedal controls START, BRAKE RELEASE
- left pedal releases the spindle brake
- right pedal works as parallel START-button
Double foot pedal controls SPEED, BRAKE RELEASE
- left pedal releases the spindle brake
- right foot pedal controls spindle speed depending on pressing level
Maximal speed, accelerate and decelerate ramp may be set up by PEDAL button.
Speed set up like this, is valid for assigned block (program) and it is independent on speed
programmed, in single program steps. Explain as: max.speed (ordinary lower) set up by START
pedal may be different, then max.speed set up by START-button.
If we require the same max.pedal speed as speed, programmed in single program step, we
need to press multifunction button PROGRAM.
+
-
12 / ERN C
PEDAL
PEDAL
2
3
5
6
8
9
C
.
2
3
5
6
8
9
C
.
1
4
0
7
1
4
0
7
1
4
0
7
1
4
0
7
ENTER
Dec. ramp for STOP button
STOP RAMP
1
STOP RAMP
1
PEDAL setup
PROGRAM
PEDAL setup
PROGRAM
Range: 0 - 12000 [rpm]
enter spindle speed !
Range: 0 - 12000 [rpm]
enter spindle speed !
250
250
PROGRAM
SPEED
PROGRAM
SPEED
Accel/Dec
1
Accel/Dec
1
