7.2 Step parameters programming
7.2.1 Basic step types
Every step can be programmed as SHIFT
,
WINDING, JUMP, DELAY or GEAR.
Shift
- spindle is not turning and the wire guide is shifting to the programmed coordinate
Winding
- defined by the following parameters: number of turns, speed and spindle direction,
pitch, left and right reversal point
Jump
- spindle is not turning and the wire guide is shifting from its position to the left or right,
in accordance with the programmed value
Delay
- spindle and wire guide are idle, the duration of the pause depends on the programmed time
Gear
- setting of requested gear, provides change of gear during cycle
26 / ERN T / V 1.3
7.2.2 Wire guide shift
Coordinating of the shift
Speed of the shift
The speed of shift is preset to 100 mm/sec during the programming stage.
If lower speed is required, this can be changed as follows:
PROGRAM
PROGRAM
1
1
2
1
Содержание ERN 100T
