TL-WR702N
150Mbps Wireless N Nano Router
- 24 -
Figure 3-20 Quick Setup - Wireless Security Settings
This page is for setting wireless security of
your own AP
. When computers and mobile phones
are connected to the AP, they should input the same password.
¾
Disable Security -
The wireless security function can be enabled or disabled. If disabled,
the wireless stations will be able to connect the Router without encryption. It is
recommended strongly to enable security.
¾
PSK Password -
ou can enter
ASCII
or
Hexadecimal
characters. The default password is
the last unique eight numbers of each Router’s MAC address
For
ASCII
, the key can be made up of any numbers 0 to 9 and any letters A to Z, the length
should be between 8 and 63 characters.
For
Hexadecimal
, the key can be made up of any numbers 0 to 9 and letters A to F, the
length should be between 8 and 64 characters.
Please also note the key is case sensitive, this means that upper and lower case keys will
affect the outcome. It would also be a good idea to write down the key and all related wireless
security settings.
3. Click
the
Next
button in Figure 3-21. You will then see the
Finish
page. Click the
Reboot
button to make your wireless configuration take effect and finish the Quick Setup.
Figure 3-21 Quick Setup - Finish
3.2.5 Client Mode
When you choose
Client
on
Working Mode
page in Figure 3-5
, take the following steps:
1. Click
Next
in Figure 3-5, and then
Wireless Client
page will appear as shown in Figure 3-22.
