PW-AN401/PW-AN401D
150M Wireless N Access Point User Guide
54
Click the
Start
button to start wireless throughput monitor.
Click the
Stop
button to stop wireless throughput monitor.
4.7.7 Wireless Statistics
Selecting
Wireless
>
Wireless Statistics
will allow you to see the wireless transmission
information in the following screen shown in Figure 4-25.
Figure 4-25 Statistics of the device attached wireless stations
¾
MAC Address -
Shows the connected wireless station's MAC address
¾
Current Status -
The connected wireless station's running status, one of STA-AUTH /
STA-ASSOC / STA-JOINED / WPA / WPA-PSK / WPA2 / WPA2-PSK / AP-UP / AP-DOWN /
Disconnected
¾
Received Packets -
packets received by the station
¾
Sent Packets -
packets sent by the station
You cannot change any of the values on this page. To update this page and to show the current
connected wireless stations, click the
Refresh
button.
If the numbers of connected wireless stations go beyond one page, click the
Next
button to go to
the next page and click the
Previous
button to return the previous page.
)
Note:
This page will be refreshed automatically every 5 seconds.
4.8 DHCP
DHCP stands for Dynamic Host Configuration Protocol. The DHCP Server will automatically
assign dynamic IP addresses to the computers on the network. This protocol simplifies network
management and allows new wireless devices to receive IP addresses automatically without the
need to manually assign new IP addresses.
There are three submenus under the DHCP menu (shown as Figure 4-26):
DHCP Settings
,
DHCP Clients List
and
Address Reservation
.
Clicking any of them will enable you to configure
the corresponding function. The detailed explanations for each submenu are provided below.
