Toyotomi KENTO Series, Руководство пользователя

Страница: 43 / 48

43
GB
DEHUMIDIFIER
TROUBLE SHOOTING
Before you call for service, review this list. This list indicates common
occurrences that not the result of a defect in workmanship or materials.
Problem Possible Cause Solution
The appliance does
not starts
The appliance is unplugged Plug in properly
Indication Bucket full fl ashes.
(Water bucket is full or has not
been placed properly)
Empty the water from the
bucket and replace the bucket
properly to its initial position
Power failure Wait 3 minutes after the power
is back on
Room temperature is higher than
35
℃ or lower than 5 ℃
Auto Protection system from
extreme temperature condi-
tions. The appliance will start
working again when room tem-
perature is within normal range
Dehumidi fi er does
not dry the air as it
should
Air fi lter is blocked Clean the fi lter and install it to
its initial position properly
Not enough time allowed for unit
to remove moisture When fi rst installed, allow at
least 24 hours to maintain the
desired dryness
Humidity control may not be set
low enough
For dryer air, press button
to lower the percent humidity
desired in the room or set the
dehumidi
fi er to CO for maxi-
mum dehumidi fi cation
Doors or windows are not properly
closed Close properly all doors and
windows
Cloth dryers may be blowing
moist air into the room Install the dehumidi fi er away
from cloth dryers. Cloth dryers
should be vented outside
Air fl ow is restricted Remove all obstacles from
inlets and outlets of the appli-
ance
Air does not come
out The fi lter is blocked Clean the fi lter based on the
given instructions
Noisy operation
The appliance leans or is not
located on
fl at surface
Move the appliance in upright
position to
fl at surface
The fi lter is blocked Clean the fi lter based on the
given instructions