SCION tC
2008-
ILLUMINATED
DOOR
SILLS
Procedure
Page 9 of 17 pages
Issue: C 06/13/07
(c)
Route the power harness to the vehicle
harness behind the connector block as
shown. (Fig. 3-3)
(1)
Secure both sides of the fuse with two
wire ties.
(2)
Route the wire from the fuse holder in
front of the connectors and secure with
one wire tie.
(d)
Attach the fuse holder connector to the T-Tap
on orange wire and reinstall the blue 22 pin
connector. (Fig. 3-4)
(1)
Make sure that the quick disconnect is
installed properly to T-Tap.
(e)
Route the long ground wire coming out of
the connector up and behind the junction
block. Secure the wire with two wire ties to
the OE harness. (Fig. 3-5)
(f)
Continue to route the ground wire to the front
of the junction block. Attach it to the T-Tap
on the orange wire and reconnect the 30 pin
connector. (Fig. 3-6)
(1)
Make sure that the quick disconnect is
installed properly to T-Tap.
Fig.
3-6
Fig.
3-3
Wire Ties
Fuse Holder
Wire
Wire Tie
Wire Cutters
Fig.
3-5
Wire ties
Behind
junction
block view
Wire Cutters
Fuse box
Fig.
3-4
Driver side
cowl area
Blue 22 pin
connector
