Toyota Previa, Руководство пользователя

Страница: 92 / 175

87
1 2 3 4 5 6 (Preset buttons)
These buttons are used to preset and
tune in radio stations.
To preset a station to a button: Tune in the
desired station (see “TUNE”). Push and
hold down the button until you hear a
beep—this will set the station to the but-
ton. The button number will appear on the
display.
To tune in to a preset station: Push the
button for the station you want. The button
number and station frequency will appear
on the display.
These systems can store one AM and one
FM station for each button. The preset
station memory will be canceled out if the
power source is interrupted (battery dis-
connected or fuse blown).
AM
⋅
FM
Push “AM
⋅
FM” to switch between the AM
and FM bands. “AM” or “FM” will appear
on the display.
If the audio system is off, you can turn on
the radio by pushing “AM
⋅
FM”.
BAL (Balance)
This knob lets you adjust the balance be-
tween the right and left speakers.
Push “BAL/FADE” so that it pops out of its
retracted position. Turn the knob to adjust
the balance. Push the knob back into its
retracted position.
BASS
This knob lets you adjust the bass level.
Push “BASS/TREB” so that it pops out of
its retracted position. Turn the knob to ad-
just the bass. Push the knob back into its
retracted position.
FADE
This knob lets you adjust the balance be-
tween the front and rear speakers.
Push “BAL/FADE” so that it pops out of its
retracted position. Pull out the knob. Turn
the knob to adjust the front/rear balance.
Push the knob back into its retracted posi-
tion.
PWR VOL (Power Volume)
Push “PWR VOL” to turn the audio sys-
tem on and off. Turn the “PWR VOL” knob
to adjust the volume.
SCAN
When you push “SCAN”, the radio finds
the next station up the station band, plays
it for 5 seconds, and then scans again. To
select a station, push “SCAN” a second
time.
ST (Stereo reception) display
Your radio automatically changes to ste-
reo reception when a stereo broadcast is
received. “ST” appears on the display. If
the signal becomes weak, the radio re-
duces the amount of channel separation
to prevent the weak signal from creating
noise. If the signal becomes extremely
weak, the radio switches from stereo to
mono reception.