Toyota ECO 26 A-SP20, Инструкция по эксплуатации

Страница: 16 / 52

16
6
7
4
From the inside, pass the thread
end through the hole in the
bobbin, as shown.
Place the bobbin on to the
thread winding spindle so the
groove will meet the shaft
projection.
Hold the thread end, and push the thread
winding switch to the left to start winding.
After winding a little, release the thread
winding switch so that it returns to the right
and stops winding.
Note: The thread is wound only while the
thread winding switch is pushed to
the left.
5
Thread
Shaft projection
Thread winding
spindle
Groove
right wrong
To stop winding the thread, release the
thread winding switch.
Attention
Do not wind excessively,
it causes sewing
malfunction.
Cut the thread.
Remove the bobbin from the spindle.
Hole
8
Cut extra thread above the bobbin hole.
Push the thread winding switch to the
left again.
Wind the thread to the amount you need.
9
10
11
Bobbin
Attention
If the thread tail remains
from the bobbin hole, please
cut it, otherwise sewing will
not be performed correctly.