L1
L2
L1
L2
D02612
L2
L1
L2
L1
D01201
L2
L1
L2
L1
D01202
−
INTRODUCTION
REPAIR INSTRUCTION
01
−
5
1CD
−
FTV ENGINE REPAIR MANUAL (RM1046E)
NOTICE:
Do the torque checking with the lower limit value of the torque tolerance.
(4)
Depending on the seal lock agent to apply, there may be a case where it is necessary to leave
it for a specified time until it hardens.
(b)
Gaskets:
When necessary, use a sealer on gaskets to prevent leaks.
(c)
Bolts, Nuts and Screws:
Carefully observe all specifications for bolt tightening torques. Always use a torque wrench.
(d)
Torque When Using Extension Tool with Torque Wrench:
(1)
In case of tightening by extending the entire length
of the torque wrench combined with SST or tool, if
you tighten until the reading of the torque wrench
reached the specified torque value, the actual
torque becomes excessive.
(2)
In this text, only the specified torque is described.
In case of using SST or extension tool, find the read-
ing of the torque wrench by the formula.
(3)
Formula T’=T x L2/(L1 + L2)
T’
Reading of torque wrench
{
N
×
m
(
kgf
×
cm
,
ft
×
lbf
)}
T
Torque
{
N
×
m
(
kgf
×
cm
,
ft
×
lbf
)}
L1
Length of SST or tool (cm)
L2
Length of torque wrench (cm)
10.
REMOVAL AND INSTALLATION OF FUEL CONTROL PARTS
(a)
Place for Removing and Installing Fuel System Parts:
(1)
Place with good air ventilation and without anything flammable such as welder, grinder, drill, elec-
tric motor or stove in the surroundings.
(2)
Never work in a place like a pit or nearby pit as there is a possibility that vaporized fuel fills those
places.
(b)
Removing and Installing of Fuel System Parts:
(1)
Prepare a fire extinguisher before starting the operation.
(2)
For prevention of the static electricity, install a ground on the fuel changer, vehicle and fuel tank,
and do not spray much water so as to prevent slipping.
