8
NOTE: The space between the wick adjuster and the primary air tube
should be even all around.
NOTE: Make certain the top of the wick adjuster and the top of
primary air tube are the same height. If they are uneven, the
flames tend to be uneven, too.
15. Tighten the four (4) wing nuts around the wick adjuster.
16. Operate the wick adjuster knob to be sure the wick moves smoothly
up and down.
AFTER REPLACING THE WICK, CHECK THE OPERATION OF THE
AUTOMATIC EXTINGUISHER.
Wick height on position
1
of wick life extender should be 10 mm,
when wick adjuster knob is fully clockwise. Be sure to check.
NOTE: Remember always start new wick on position
1
of wick life
extender.
NOTE: If wick does not move smoothly and easily, or wick height is
more or less 10 mm, do not use heater, disassemble and repeat
items 11 through 16.
NOTE: If any ragged edges appear on the top of the wick, trim them
with a scissors carefully. DO NOT cut the body of the wick.
Remove the wick adjuster knob from the wick adjuster shaft once
more.
17. Replace the cabinet and secure it into position with three (3)
screws.
Replace the wick adjuster knob on the wick adjuster shaft. Install
the heat chamber. Grasp the wire handle, them turn the heat
chamber left and right to insure that it is properly seated. Once
again check the proper operation of the automatic extinguisher.
NOTE: Before lighting a new wick for the first time, turn the wick to its
lowest position. Allow the wick to saturate with kerosene for
thirty (30) minutes.
18. Put the batteries into the battery holder.
Space
Top of
primary
air tube
Top of
wick
adjuster
Wick
Wick
adjuster
Primary
air tube
*Wick height
Wick
10 mm
Model RCA-2800 (E) 06.12.12 9:08 AM ページ 8
