ASSEMBLY AND OPERATION
INSPECTION AND ASSEMBLY
NOTE:
Please save the shipping carton packing materials for future storage of your heater.
1. REMOVE PACKING MATERIALS
Open the grille by raising the lower right hand corner of grille and pulling straight out. Remove
the styrofoam packing wedge from under the top plate of cabinet to release the heat chamber
assembly. Lift the heat chamber, in its protective packing, out of the cabinet.
2. REPLACE THE HEAT CHAMBER
Remove the cardboard packing, and replace the heat chamber assembly. Point the wire handle
to the front of the heater.
Close the grille.
3. INSTALL THE BATTERIES
Locate the battery holder on the back of your heater.
¡
Insert the battery 2 “D” size batteries according to the plus (+)
and minus (–) markings.
4. CHECK THE HEAT CHAMBER
If the chamber is raised, put it down and inlay it.
NOTE:
If the heat chamber is raised, it can cause smoke and soot.
FUELING
WARNING:
Use only clean kerosene.
Never use gasoline or other flammable liquids.
1
Manual shuto
1. Open the fuel tank
removable fuel ta
remove the fuel ta
2. Insert the straight
container. Insert t
fuel tank opening.
3. Turn the air vent k
the vent. Start the
siphon vigorously
longer necessary t
4. Watch the fuel gau
When it shows h
counterclockwise.
NOTE:
Be careful
very cold
expansion
5. Remove the sipho
container. replace
kerosene from tan
6. After making sure f
Model RCA-2800 (E) 06.12.12 9:08 AM ページ 1
