5056.42562
Fig. #24
Linking the remote control unit to the
wall switch.
1. Begin by moving the selector toggle
on the wall switch to the “REMOTE”
position.
2. Insert a straightened paper clip into
the “PROGRAM” slot on the wall
switch.
3. Press the internal “PROGRAM” button
once and wait until you hear 3 beeps
from the wall switch.
4. Press the ON/OFF button of the
remote unit. Once the wall unit beeps
3 times, the remote is programmed.
5. The toggle on the wall switch must be
kept in the “REMOTE” position in order
to use the remote control unit.
The NV / PV (Natural Vent / Power Vent) switch (Fig #27) on the interface board (Fig #23)
is set according to which type of evacuating vent system is present. If the fireplace is
vented without the assistance of a power vent, the switch should be set to “NV”. If using a
power vent, “PV” should be selected. Follow the instructions provided with the power vent
kit for proper installation.
TO FIREPLACE
Fig. #25
Fig. #26
Wall Switch and Remote Control
Selecting Natural Vent and Power Vent Modes
Fig. #27
15
TC54_D 030615-40
