Tower Hobbies 424, Руководство пользователя

Страница: 13 / 16

13
•
NEVER allow the transmitter’s throttle stick to accidentally be moved away from
the “idle” or minimum position while the model’s engine/motor is moving.
•
ALWAYS range check the radio system before use.
•
ALWAYS make sure that all transmitter stick movements operate all servos
properly in the model. Check the proper operation of control surfaces before and
after starting the engine/motor.
•
Do not store your radio equipment in hot or cold locations, in direct sunlight, in
locations with high humidity. Store R/C equipment in cool and dry locations.
•
Do not allow chemicals to come in contact with any parts of the radio system.
Substances such as glow fuel, gasoline, CA glue, etc. could permanently damage
plastic parts of the radio system.
•
If rechargeable batteries were installed in the Tx, remove the batteries before
placing the radio in long-term storage.
TROUBLESHOOTING
RANGE IS SHORT:
In terference – check Rx installation. Rx may need to be located to a different
position in the model for better reception.
Weak Tx or Rx battery – replace the batteries or recharge as applicable.
Crash damage – send the radio to Hobby Services for repair.
RUN TIME IS SHORT:
Weak Tx or Rx batteries – replace or recharge the batteries.
Ob structed servo linkages causing excess battery drain – free the linkages /
pushrods.
Tx ON BUT SERVOS DO NOT FUNCTION:
Weak Tx or Rx batteries – replace or recharge the batteries.
Rx switch is in the off position – turn on the switch harness or ESC.
Sw itch harness or ESC is connected incorrectly – check all connections and
the ESC instruction manual.
Rx is not linked to the Tx properly – perform linking process again.
INTERFERENCE OR GLITCHING SERVOS:
Out of range – operate the model more closely to the Tx.
Rx located too closely to engine, motor, or servos or other moving mechanical
parts which might be creating unwanted electrical noise – relocate the Rx
inside the model or relocate the ESC.
CONTROL SURFACE MOVES IN THE WRONG DIRECTION: Reverse the
position of the reversing switch for the appropriate channel.