Tower Hobbies 424, Руководство пользователя

Страница: 7 / 16

7
FLIGHT EQUIPMENT INSTALLATION
LED Link button
CH4 Rudder servo
CH3 Throttle
CH2 Elevator servo
CH1 Aileron servo
BAT Battery
(electronic speed
control or servo)
RECEIVER (RX):
Follow the instructions included with the model for installation
of the receiver. It’s a good idea to protect the Rx by wrapping it with foam rubber,
and attach it fi rmly inside the model to prevent unwanted movement during fl ight.
Rudder
Servo
(Ch4)
Receiver
Throttle
Servo
or ESC
(Ch3)
Elevator
Servo
(Ch2)
Aileron
Servo
(Ch1)
Switch Harness
To Rx Battery
To Charger
6-CHANNEL RECEIVER
SPREAD
SPECTRUM
SERVOS: Servos are not included with this radio and must be purchased
separately. Follow the instructions included with the model for installation of the
servos. Center all trims on the transmitter. Connect linkages properly, but do not
over-tighten the mounting screws as servos should have slight movement to
compensate for engine vibration. Pushrods should be snug and not bind during
movement, and allow the servo to have full range of movement by moving the Tx
sticks to maximum rotational positions several times while observing the movement
of the control surfaces. Adjust linkages as necessary to prevent unwanted battery
drain due to linkage/pushrod obstructions. Connect the servos to the receiver as
shown in the diagram. Make sure to install wires to not interfere with other moving
parts inside the model.
ELECTRIC MODELS: For models using electric power for fl ight, an optional
ESC (electronic speed control) is needed to control speed of the motor. Most ESCs
also supply power to the receiver. Refer to the ESCs instructions to determine the