KTM Lc8 Xenon-Fog light
Installation Instructions
TOURING RALLYE RACING TECHNOLOGY
09-370-0101-1
These instructions are at our present level of knowledge.
Legal requirement for correctness do not exist. Thechnical issues subject to change.
Fog light wiring:
Attach the relay on fairing support.
Route the brown cable on the right side of the
frame to the battery.
Shorten the cable to correct lenght and connect it
to the minus pole with a connector.
Route the blue-red cable to the fog light and the
light switch on the handle bar. Mount the light
switch with supplied handlebar clip on the left side
of the handlebar. Use two dome crews M4x10 and
two M4 nuts. Adjust the switch so that it can be
operated vertically.
Shorten the blue-red cable to fit and route them
thru the holes on the underside of the fog light
cover. Attach the supplied blade connector on the
cable.
Connect the blue cable on the outside right ground
pole on the light.
Connect the red cable directly on the light and
secure it with a zip tie.. Put the cover back on the
light. (Top picture)
Route the yellow cable to the low beam connector
and connect it right behind it with green cable.
In order to make the light installation easier you can
separate the yellow from the original loom at the
hight of the original connector and connect it with
a blade connector.
Install original headlight on the fairing support,
connect the battery, test the installation and adjust
the lights.
