Toto NEOREST DH TCF9575 Series, Инструкция по эксплуатации

Страница: 62 / 76

61
Resupplying the Water
1
Open the shutoff valve.
(Page 15)
•
Check that water is not leaking from a pipe or the top unit.
2
Switch the breaker on the distribution board to ON.
•
The "Power" LED lights up.
3
➀
Discharge water from the wand.
(1) Pressing down the left side of the toilet seat,
(2) Press "Rear cleansing" button to discharge water from
the wand.
•
Catch the water in a paper cup or other receptacle.
(3) Press "Stopping" button.
➁
Press "Full fl ush" button.
•
The tank fi lls with water (in models for sale in Hong Kong, Indonesia and Malaysia, water also fl ows
into the bowl unit.)
The LED on the main display
fl ashes. It stays lit after the tank becomes full (about 60 seconds max.
(about 80 seconds max. in models for sale in Hong Kong, Indonesia and Malaysia)).
•
You cannot fl ush the toilet until water supply is complete. Never operate the toilet while the tank is
fi lling with water.
■ If the remaining water has frozen and no water comes out
•
Heat the inside of the bathroom, and warm the water supply hose and shutoff valve using a cloth
soaked in warm water.
4
After the bowl unit fi lls with water, press "Full fl ush" button again.
Soft cloth soaked in water
(to prevent scratching)
Paper cup
6
Pull out the water drain lever.
•
Water comes out from around the wand (about 20 seconds)
Water drain lever
7
Release your hand to return the water drain lever to its original position.
■
If water may get frozen
•
Add antifreeze solution in the water in the bowl to prevent freezing.
(The antifreeze solution should not be
fl ushed out. Collect it before using the toilet and dispose of it.)
■
To use the product again
•
The water needs to be resupplied. (See below)
Reference