56
What to Do?
If the water does not
fl
ow due to a power outage
1
Remove the side panel (left).
2
Pull the hand lever to where it
stops. (about 30 seconds)
• The water surface in the bowl rises.
Keep
pulling
Hand lever
(For
fl
ushing in
case of power
outage)
Rises to this level
No water in the
bowl over
fl
ows.
3
When the beep sound is made
and water supply stops, release
the hand lever.
• The toilet
fl
ushes.
•
You cannot
fl
ush the toilet for about 60
seconds after
fl
ushing it or releasing the
hand lever halfway.
Wait at least about 60 seconds and then
fl
ush the toilet again.
Release
4
Reinstall the side panel.
• Fit the side panel to the top and side of the
bowl unit without a gap.
Attention!
•
When the power is restored, be sure to perform a full
fl
ush.
(To prevent waste from remaining in the drain pipe.)
•
You can
fl
ush the toilet with a bucket. (Page 58)
Side of the bowl unit
Top of the bowl unit
■
You can
fl
ush the toilet with the hand lever (for
fl
ushing in case of power outage).
●
Pulling the hand lever does not
fl
ush the toilet when the power is supplied.
When testing the operation, switch the breaker on the distribution board to OFF.
If the water does not
fl
ow due to a power outage (when water failure hasn't occurred)
Содержание NEOREST DH TCF9575 Series
Страница 52: ...51 3 Select or ENGLISH LANGUAGE ENGLISH Press LANGUAGE ENGLISH To return Reference...
Страница 75: ...74 MEMO...
Страница 76: ...75 MEMO...