Toto 20899, Руководство пользователя

Страница: 20 / 96

•
If the oil level on the dipstick is too low,
carefully pour a small amount of oil into the
oil-fill tube, wait 3 minutes, and repeat steps
8 through 10 until the oil level on the dipstick
is correct.
•
If the oil level on the dipstick is too high,
drain the excess oil until the oil level on the
dipstick is correct.
Important:
If the oil level in the engine is too
low or too high and you run the engine, you
may damage the engine.
11. Install the dipstick into the oil-fill tube securely.
12. Recycle the used oil properly.
Lubricating the Upper
Handle
Service Interval: Yearly
Lubricate the left and right sides of the upper handle
with a low-viscosity silicone spray lubricant.
1. Spray the outer plastic end of the inner handle
(
Figure 44 ).
g010349
Figure 44
Note:
Use the straw that comes with the spray
can to direct the spray.
2. Push the upper handle fully down and spray the
inner plastic surface of the outer handle (
Figure
45 ).
g010350
Figure 45
Adjusting the Self-Propel
Drive
If your machine does not self-propel properly, adjust
the self-propel-drive cable.
1. Loosen the nut on the cable mount ( Figure 46 ).
g010351
Figure 46
1. Cable mount
2. Pull the upper handle back fully rearward.
Note:
If the handle does not move smoothly,
refer to Lubricating the Upper Handle (page 19) .
3. Pull the cable jacket downward until you remove
the slack in the exposed cable (
Figure 47 ).
g007744
Figure 47
1. Exposed cable
4. Push the cable jacket upward 3 mm (1/8 inch).
Note:
You can place a ruler against the upper
side of the black cable mount and measure how
far the upper end of the cable jacket moves
(
Figure 48 ).
19