Total TG1252306, Инструкция по эксплуатации

Страница: 10 / 15

10
Functioning
Attention
It should never be necessary to force the tool. The weight of the tool applies adequate
pressure. Excessive force and pressure can cause dangerous wheel breakage. Never
turn on the tool when it is in contact with the workpiece, it may cause injury to the
operator.
Replace blade if tool falls off during grinding. Do not hit the tool, wheel or grinding wheel
against any surface. Prevent the disc from bouncing and snagging, especially when
working around corners, sharp edges, etc. This can lead to loss of control and kickback.
Never use tools with saw blades to cut wood and other saw blades. These blades, when
used on a grinder, frequently kick and cause loss of control and lead to personal injury.
Always wear suitable protective clothing such as safety glasses or face shield during
operation.
After use, always turn the tool off and wait until the blade has come to a complete stop
before putting the tool down.
Polishing and sanding operation
•
Hold the tool firmly with one hand on the tool
handle and the other on the side or auxiliary
handle.
•
Turn on the tool and apply the wheel to the
workpiece.
•
In general, keep the edge of the disc at an
angle of approximately 15 degrees to the
surface of the workpiece.
Wire cup brush operation (optional accessory)
Attention
Check brush operation by running the tool without load, making sure no one is in front of
or in line with the brush.
Do not use a brush that is damaged or unbalanced. Using a damaged brush could
increase the possibility of injury from contact with broken brush cables.
Unplug the tool and turn it upside down to allow easy access to the shaft. Remove all
accessories from the shaft. Mount the washer, then thread the wire cup brush onto the
shaft and tighten with the wrench provided. When using a brush, avoid applying too much
pressure, which causes the wires to bend excessively and cause premature breakage.
1. Wire cup brush
2. Urethane washer