Total TG1252306, Инструкция по эксплуатации

Страница: 12 / 15

12
•
In the case of cutting stone or brick, it is recommended to use a dust extractor.
The electronic control allows a continuous preselection of the speed according to
the material to be worked. Constant electronic control keeps the preset impact
rate nearly constant between no-load and load conditions.
Maintenance and troubleshooting
Maintenance
Always make sure the tool is turned off and unplugged before attempting inspection or
maintenance.
Never use gasoline, thinner, alcohol or the like. Discoloration, deformation or cracking
may occur.
The tool and its air vents must be kept clean. Clean the tool's vents regularly or whenever
the vents begin to clog.
Brush replacement
Use a screwdriver to remove the brush holder caps. Take out the worn brushes, insert
the new ones, and secure the brush holder caps.
1. Exhaust ventilation
2. Inhalation vent
1. Commutator
2. Carbon brush
1. Brush holder cap
2. Screwdriver