Total P20S, Руководство пользователя

Страница: 7 / 18

7
•
Always use the proper flanges for the correct size and design of discs. Flanges
for cut-off wheels may be different from flanges for grinding wheels.
• Do not use worn wheels from larger power tools. The blade intended for a
larger power tool is not suitable for the higher speed of a smaller tool.
Abrasive cutting operations
• Do not "jam" the disc or apply excessive pressure. Overloading the disc
increases susceptibility to binding and the possibility of kickback or breakage.
•
Do not place the body near the cutting area of the blade. When the wheel locks
up at the point of contact and in the event you stomp, that kickback will direct
the tool toward your body.
•
When the blade jams for any reason, turn off the tool and hold it still until it
comes to a complete stop. Never try to remove the cutting disc by turning the
tool on again, otherwise kickback may occur. Investigate and take corrective
action to eliminate cause of stall.
•
Do not restart the cutting operation on the workpiece. Let the blade come up to
full speed and carefully recut. The wheel can bind, ride up, or kick back if the
power tool is restarted on the workpiece.
•
Any large work piece to minimize the risk of pinching and kickback of the blade.
Large workpieces tend to give way under their own weight. Supports should be
placed under the workpiece near the line of cut and near the edge of the
workpiece on both sides of the blade.
•
Use extreme caution when making a "pocket cut" in existing walls or other blind
areas. It may cut gas or water pipes, electrical wiring, or objects that can cause
kickback.
Sanding operations
• Do not use oversized discs. Follow the manufacturer's recommendations when
selecting sandpaper. Sandpaper that extends past the sanding pad presents a
hazard and can cause binding and kickback.
Polishing operations
• Do not allow the residue of any polishing flecks to spin freely. Please remove or
clip them because otherwise they may harm the work or your own body.
Wire brushing operations
• Please note that the brush sheds wire bristles even during normal operation. Do
not overload the cables by applying excessive load to the brush. Wire bristles
can easily penetrate light clothing and/or skin.
•
The use of a wire brush guard is recommended. The wire disc or brush may
expand in diameter due to work load and centrifugal forces. Do not allow wire
wheel or brush to interfere with protection.
Other risks
Even when the power tool is used as prescribed, it is not possible to eliminate all
residual risk factors:
a. Health defects resulting from vibration emission if the power tool is used for a
longer period of time or if it is not managed and maintained properly.
b. Injuries and property damage due to broken fixtures breaking suddenly.