Total P20S, Руководство пользователя

Страница: 16 / 18

16
stone, and brick. Diamond impregnated wheels are available for harder
materials.
• If the grinder is used on soft metals, such as aluminum, the disc may bind and
will need to be replaced.
• At all times, let the sander do the work, do not force it or apply excessive
pressure to the discs.
• If a slot is cut, make sure the cutter stays aligned with the slot, if you twist the
cutter, the disc may break. If cutting a thin sheet, only allow the cutter to
protrude through the material, excessive penetration can increase the chance of
damage.
• In case of cutting stone or brick, it is recommended to use a dust extractor.
•
The electronic control allows a continuous preselection of the speed according
to the material to be worked on. Constant electronic control maintains the
preselected impact rate nearly constant between loaded and unloaded
conditions.
Maintenance and troubleshooting
Maintenance
Make sure the tool is unplugged from power before performing any maintenance.
•
Keep the ventilation slots clean and free of obstructions. If possible, blow
compressed air into the vents to remove internal dust (safety glasses should be
worn when doing this).
•
Keep the outer casing of the tool clean and free of grease. Do not wash with
water or use solvents or abrasives. Use only mild soap and a damp cloth to
clean the tool. Never let liquid get inside the tool. Never immerse any part of the
tool in liquid.
•
Your grinder does not require additional lubrication.
•
Always store your power tool in a safe, dry place.
• If you see some small sparks flashing from the ventilation slots, this is normal
and will not damage your power tool.
Problem solving
Although your grinder is actually very simple to use, if you experience problems, check
the following:
• If it is not working, check the power supply at the mains connection plug.
•
If the disc wobbles or vibrates, check that the outer flange is tight; check that
the disc is correctly positioned on the flange plate.
• If there are signs that the disc is damaged, do not use it as the damaged disc
may disintegrate, remove it and replace it with a new one. Dispose of old discs
correctly and responsibly.
•
If working with aluminum or the like, the disc will soon clog and will not sand
effectively.
Note: If you cannot find the fault, contact your official Total dealer.