Total P20S, Руководство пользователя

Страница: 13 / 18

13
Installation or removal of abrasive disc (optional accessory)
• Mount the rubber pad on the shaft.
•
Place the disc on the rubber pad and screw the locknut onto the spindle.
• To tighten the locknut, press firmly on the spindle lock so that the spindle
cannot rotate
•
Then use the lock nut wrench and tighten securely in a clockwise direction.
• To remove the drive, follow the installation procedure in reverse.
Note: Use sander accessories specified in this manual. They must be purchased separately.
To use the sander
•
It should never be necessary to force the tool. The weight of the tool applies
adequate pressure. Excessive force and pressure can cause dangerous disc
breakage.
• Always replace the wheel if the tool is dropped during grinding.
•
Never hit the disc or grinding wheel against the work.
• Prevent the blade from bouncing and snagging, especially when working
around corners, sharp edges, etc. This can cause loss of control and kickback.
• Never use tools with wood cutting attachments or other saw blades. Such
blades, when used on a grinder, frequently kick and cause loss of control and
personal injury.
Attention
• Never start the tool when it is in contact with the work piece, it may cause injury
to the operator.
• Always wear safety glasses or a face shield during operation.
•
After operation, always turn off the tool and wait until the blade has come to a
complete stop before putting the tool down.
Polishing and sanding operation
•
Always hold the tool firmly with one hand on the housing and the other on the
side handle. Turn on the tool and then apply the wheel or disc to the work
piece.
• In general, keep the edge of the blade or disc at an angle of about 15 degrees
to the surface of the work piece.
1. Sanding the locknut
2. Abrasive disc
3. Rubber pad