x2
4.0 x 70mm
Per Floor Section
x3
STEP • 16
STEP • 17
10
= Drill Points using
screws provided as shown
© Sheds (Midlands) Limited 2021
www.totalsheds.co.uk
FELT STRIPS
ATTACH FELT STRIPS
Create the Final Roof
Edges. Final steps
finishing off the roof.
16a.
Using the felt strips provided cover the edges of the roofs and ends of the roof felt. You will
need to measure these and saw to fit to your requirements and create the perfect roof finish as
shown below.
16b.
Drill in the felt strips as shown on front and back of the shed to finish the roof off. Use the
framework of the roof blocks to screw the felt strips down to. The felt strips will give your shed a
neat finish for the roof and hide any overhang areas of the roof felt.
NOTE:
Location of the Felt Strips
16c.
Felt Strips must be same height as roofing
felt to allow rain water to run off. See Diagram on
the right.
x3
x2
4.0 x 70mm
Per Front Top
= Drill Points using
screws provided as shown
CONSTRUCTING THE SHELF
CONSTRUCTING THE
SHELF
Adding the Two Frame
Posts and connecting
the shelves
17a.
Using the screws provided, attach the two frame posts at the end of
the top Shelf Panel. Do this by securing the posts to the frame of the top
shelf panel.
x2
4.0 x 70mm
Per Floor Section
x3
x2
4.0 x 70mm
Per Frame Post
17b.
Once the top panel is in place, measure the
distance of the framing on the inside of the window
panel from the above to the below framing of
the bottom window. This will give you the correct
placement of the second Shelf Panel. (About 10cm from
the bottom frame post).
17b
