Total Gym 5750-01, Руководство пользователя

Страница: 7 / 12

7
ASSEMBL
Y
TOTAL GYM LEG TRAINER
™
OWNER’S GUIDE | ASSEMBLY INSTRUCTIONS
Assembly Instructions
Your Leg Trainer can be assembled by one
person following the steps below.
STEP 1. Carefully unpack all the parts and
the Information & Hardware box at the
installation site if possible.
Rubber Padded
Step-Up Platform
Rail Assembly
Strut Frame
STEP 2. Open the Information & Hardware
box. Inside there will be:
Large Screws with
Large Washers (4ea)
Rubber Feet
(2ea)
Small Screws with
Small Washers (2ea)
Bent End
Ball End
8 mm Hex Wrench
10 mm Open-
End Wrench
M6 Nuts and
Washers (2 ea)
STEP 3. Install rubber feet onto the strut
frame as shown below.
STEP 4. Arrange the rail assembly on
its side, the strut frame on its side, the 8
mm hex wrench, four large screws, and
two small screws on the floor as shown
below so you can reach all the parts and
tool with both hands. Install a washer onto
each screw.
STEP 5. Lift the rail assembly into the
strut frame and align the bottom hole in
the gusset with the bottom hole in the
strut frame as shown below. Use the ball
end of the 8 mm hex wrench to partially
screw in the small screw.
STEP 6. Twist the strut frame slightly to
align the top holes to the holes in the
rail assembly. Then insert a large screw
into the top hole farthest from the back
plate on the inside of the strut frame and
partially tighten it using the ball end of the
8 mm hex wrench, as shown below.
STEP 7. Carefully turn over the Leg Trainer
and repeat STEP 5 and STEP 6.
STEP 8. Install the last large screw into
the top hole closest to the back plate on
the inside of the strut frame and partially
tighten it using the ball end of the 8 mm
hex wrench, as shown blow.