8
ASSEMBL
Y
TOTAL GYM LEG TRAINER
™
OWNER’S GUIDE |
ASSEMBLY INSTRUCTIONS
Rubber Padded Glideboard:
Roller Removal and Assembly
STEP 1.
Disconnect the Leg Trainer
from the floor and place on its side to
unscrew the Upper L-Frame beneath the
Rubber Padded Glideboard. (
NOTE:
The
image below shows the Leg Trainer from
the bottom). Use the 10 mm open-end
wrench to unscrew the three screws from
the upper L-frame.
Screw #2
Screw #3
Screw #1
Upper L-Frame
To unscrew the upper L-frame, roll the
Rubber Padded Glideboard up so you can
reach the bottom corner screw (Screw #1)
of the upper L-frame. Hold the Glideboard
in place while you remove the screw.
Once you remove the first screw, lower
the Rubber Padded Glideboard back to the
starting position and unscrew the two top
screws (Screw #2 and #3) from the upper
L-frame.
STEP 2.
Rotate the upper L-frame
clockwise to remove upper L-frame from
Rubber Padded Glideboard completely.
STEP 3.
Rotate the Rubber Padded
Glideboard clockwise until the rollers move
out of the rails; then lift it off. (
NOTE:
YOU
SHOULD NOT FEEL ANY RESISTANCE, IF
YOU DO, TURN GLIDEBOARD THE OTHER
DIRECTION).
STEP 4.
To remove the rollers use a 13
mm socket wrench and a 13 mm open-
end wrench.
Insert socket wrench over the bolt on the
outside of the roller as you engage the
open-end wrench on the nut on the inside
of the frame; turn to unscrew.
STEP 9.
Turn the Leg Trainer to the other
side and repeat Step 8.
STEP 10.
Stand the Leg Trainer upright
and completely tighten all six screws (from
Steps 4 - 9) with the Bent End of the 8
mm hex wrench.
STEP 11.
Install the Rubber Padded Step-
Up Platform to the top of the strut frame.
Locate the four slots at the top of the strut
frame, towards the back, then, holding
the Rubber Padded Step-Up Platform at
an angle, slide the pre-installed studs into
the slots and push forward until it will not
move further. Make sure all the washers
are below each slot. (
NOTE:
six studs on
the bottom of the Rubber Padded Step-Up
Platform are pre-installed).
Slots (6 total)
Pre-installed Studs (6 total)
Front
Back
STEP 12.
Lower the Rubber Padded Step-
Up Platform so the two front studs engage
the two front slots. Install a M6 nut and
washer onto each of the front studs on
the platform using the 10 mm open-end
wrench. Then tighten all six nuts on the
platform completely.
STEP 13.
Bolt the Total Gym Leg Trainer
to the floor using one bolt through each
floor anchor bolt hole. (Bolts not included).
If necessary, you can first lift the unit by
the struts and roll it to the final installation
position.
Содержание 5750-01
Страница 1: ...OWNER S GUIDE TOTAL GYM LEG TRAINER...
