Toshiba TOSDIC-CIE DS, Инструкция по эксплуатации, Страница: 32 / 158

2. Installation and Wiring
18
The I/O base unit is mounted on the DIN rail in the following sequence.
1) Lift the bottom of the communication base unit or the I/O base unit and then, while
applying the upper part of the DIN rail to the DIN rail mounting groove, move it
downwards so that the upper end of the DIN rail engages the DIN rail.
2) Push the bottom of the communication base unit or the terminal block unit toward the DIN
rail side while pressing down the tab of the lower part with a minus screwdriver, etc. so
that the unit engages the rail.
3) Slide the above leftward on the DIN rail and push it to the preceding unit's connector or
stopper until they are adhered firmly to each other.
Note:

For removal, follow the reverse of the procedure above.

Remove from the unit on the right side.
Stopper DIN rail
1)
2)
2)
3)
Figure 2.8 Mounting on the I/O Base Unit System DIN Rail