Toshiba TMC7 Series, Руководство по эксплуатации продукта

Страница: 21 / 24

ACCESSORIES
Page 21
710-02887-00A
TMC7 Series
2 0 to 7 Trip/fault code
0 = no trip
20 = motor overload
26 = current imbalance
50 = power circuit
54 = phase rotation
55 = supply frequency
75 = motor thermistor
101 = excess start time
113 = comms failure between interface and TMC7
114 = network comms failure
0 Initialised 1 = phase rotation bit is valid (bit 1) after 1
st
start
1 Phase rotation 1 = positive phase rotation detected
3
2 to 7 Reserved
4 0 to 7 Current (low byte)
5 0 to 7 Current (high byte)
current (A)
6 1 0 to 7 Current %FLC (low byte)
7 1 0 to 7 Current %FLC (high byte)
current as a percentage of soft starter FLC setting (%)
8 0 to 7 Temperature motor temperature (%)
9 to 13 0 to 7 Reserved
1 Only available from TMC7 units with serial number format xxxxx-4 or more.
5.6 AS-i Module
Part Number: TMC7-ASM-01
The AS-i Module can be used with the TMC7 to enable control and monitoring via an AS-i network.
(Under development).
5.7 PC Set-up Software
The PC Set-up Software can be used with both the TMC7 and TMS7 soft starters to provide the following functionality for networks of up
to 99 soft starters.
Feature TMC7 TMS7
Operational Control
(start, stop, reset, quick stop)
„ „
Status monitoring
(ready, starting, running, stopping, tripped)
„ „
Performance monitoring
(motor current, motor temperature)
„ „
Upload parameter settings
„
Download parameter settings
„
System Requirements
• Pentium II 266 Mhz processor
• 64 MB RAM.
• 12 MB free space on hard disk.
• Microsoft Mouse or other compatible pointing device.
• EGA, VGA, or compatible display (VGA or higher is recommended).
• An RS485 communication port or RS232 to RS485 converter
• Microsoft Windows 95, 98, 2000, NT or XP.
Additionally, each TMC7 soft starter connected to the network must be fitted with a MODBUS Module (TMC7-MBM-01) or Remote
Operator (TMC7-ROM-01).