4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33012B
4.10 RFID MODULE (B-9704-RFID-U1-US/EU)
4-45
4.10.3 Removing the Platen Frame Top and Attaching the Ribbon Guide
NOTE: When installing an RFID module, be care of the following:
1. When an RFID module is used together with a cutter module or strip module, install the RFID
module first.
2. If the B-4205-QM swing cutter has been installed, remove the cutter unit before installing an
RFID module.
3. If the B-8204-QM rotary cutter has been installed, remove the cutter unit and the cutter drive unit
before installing an RFID module.
4. If the B-9904-H-QM strip module has been installed or in case of the B-SX5T, remove the
rewinder guide plate and strip sensors before installing an RFID module.
1) Remove the two black screws to detach the front plate. (Refer to section 4.1.)
2) Remove the side panel (L) from the printer. (Refer to section 3.2.)
3) Push the Hook through the rectangle hole with a jeweler’s screw driver or something, and
remove the Platen Holder Cover in the direction indicated by the arrow.
4) Lift the right side of the Strip Plate, and then pull and remove it.
5) Remove the Platen and the Platen Holder in steps 1 to 3 as shown below.
Strip Plate
Hook
Platen Holder Cover
1
2
2
1
Platen
Platen Holder
1
2
3
Push
