4. INSTALLATION PROCEDURE FOR OPTIONAL EQUIPMENT
EO18-33012B
4.14 STRIP MODULE (B-9904-H-QM-R)
4-95
NOTES: 1. You should change the selection switch setting depending on the issue mode. Improper setting may
affect the print quality.
STANDARD/PEEL OFF (STRIP):
Batch or strip mode
REWINDER:
Built-in rewinder mode
For the cut mode, the selection switch can be set to
either position.
2. The backing paper can be wound directly onto the Take-
up Spool or a paper core. When using the Take-up
Spool, detach the holder stopper by removing the B-3x4
screw. Otherwise, it may be difficult to pull out the wound
backing paper roll. When using a paper core, put the core
on the Take-up Spool with the Holder Stopper on it, and
attach the top edge of the backing paper to the core with
adhesive tape. The Take-up clip is not necessary.
This winding method is applicable to the Built-in Rewinder
mode.
17) Fix the longer harness of the rewind full sensor and the rewinder harness under the Main PC board
with the cable clamp.
18) Turn the head lever counterclockwise to Free position.
19) Open the ribbon shaft holder plate.
Selection Switch
Holder Stopper
Take-up Spool
B-3x4
Screw
Take-up Clip
Ribbon Shaft Holder Plate
Cable Clamp
Rewinder Harness
Longer Harness of the
Rewind Full Sensor (Tr)
Main PC Board
PS Unit
Head Lever
Lock position
(Label)
Lock position
(Tag)
