36
M
a
i
n
t
e
n
a
n
c
e
&
T
r
o
u
b
l
e
s
h
o
o
t
i
n
g
8 Align the new lamp module in the correct direction.
9 Gently push the module in as far as it goes.
10 Tighten the screws on the outside of the module.
11 Slide the lamp connector to the left to re-attach it.
12 Insert the tabs at the top of the lamp door into the projector and press
the lamp door into place.
13 Plug in the power cord and turn the projector back on.
14 To reset the lamp hour counter in the Status window, press and hold
the left mouse button, then press the menu button (while still holding
down the mouse button) for 5 seconds. Verify that the counter was
reset by pressing the menu button and viewing the counter in the
Status window.
Replacing the Batteries in the Remote Control
The life of the batteries depends on how often and how long you use the
remote. Symptoms of low battery charge include erratic responses when
using the remote and a reduced range of operation.
Follow these steps to replace the batteries:
1 Turn the remote face down in your hand.
2 Slide the battery cover off the end of the remote by pressing on it
with the heel of your hand.
3 Remove the old batteries.
4 Install two new AAA alkaline batteries. Make sure you install each
in the correct direction.
5 Slide the battery cover back on the remote.
