Installation
Step 2: Program CTX for the Console
Strata CTX Attendant Console Installation 03/03
5
Step 2C: Make DKT Data Assignments on CTX
1. Enter Program 204, enter the Prime DN for this particular Attendant Console.
2. Enter data for the FBs listed below:
❐
FB01 – Press
to assign the Station Type as “Attendant” (required).
❐
FB02 – Press
to assign the key strip assignments for the Attendant Console (required).
❐
FB05 – Press
to assign Tone First signaling (required).
❐
FB19 – Press
(Not Continuous) to disable continuous DTMF.
❐
FB21 – Press
to select the “BATI” adapter type (required).
❐
FB30 – Press
to disable Automatic Line Hold.
Notes
•
FB19 and FB30 settings can be changed within the CTX Attendant Console application (see
Administration view, Admin tab in the console). These two settings can be changed in CTX
programming or from the CTX Attendant Console. The console has precedence; the console
overrides programming data.
•
Although FB28 is labeled “Attd Overflow Dest.,” you should enter the overflow destination
from Program 404.
Step 2D: DKT Button Assignments
➤
Do not make any button assignments in Program 205 for the Attendant Console port. In the
previous step, Program 204, FB02, Pattern 3 (key strip assignment) enables the correct
assignments for the port (whether the console is connected to a BATI or DKT).
Note
No other telephones in the system should have an appearance of the Console’s PDN.
6441
Enter CTX Station DN
Required
Required
