Toshiba Strata CT, Инструкция по установке и обслуживанию

Страница: 63 / 385

Strata CT Installation
Strata CT I&M Manual October 2000
2-27
4. Place cabinet two on top of the bottom cabinet and connect them together at points “A”
and “B” with the screws provided.
5. Place cabinet three on top of cabinet two and connect them together at points “A” and
“B” with the screws provided.
6. If installing more than three cabinets, install wall brackets (RWBF) on the top of cabinet
three. Position the three cabinets parallel to the wall (two inches from the wall) and
secure the wall brackets to the wall with customer-provided wood screws and wall
anchors as required.
7. For systems with just three cabinets, secure the floor fixtures (already attached to the
bottom cabinet) to the floor with the customer-provided floor bolts.
8. Refer to the sub-sections that follow the appropriate procedure to anchor the system to
concrete, wood, or computer room floor.
9. Add remaining cabinets, making sure that the cabinets are connected together at points
A and B with the screws provided.
10. For systems with four or more cabinets, make sure that wall brackets (RWBF) are
installed on both sides of the top cabinet, in addition to cabinet three.
11. Check to make sure the cabinets are parallel to the wall. Secure the floor fixtures
attached to the bottom cabinet to the floor with the customer-provided floor anchors.
12. Connect the data cable of each Expansion Cabinet to the applicable data cable connector
on the Base Cabinet ( Figures 2-8 ). (The data cable from the first Expansion Cabinet
should be connected to the connector labelled “CAB. 2”, the cable from the second
Expansion Cabinet to the “CAB. 3” connector, etc.)
13. Install ground wiring, AC and reserve power cabling, and PCB cabling per the
“Recommended Installation Sequence” on Page 2-5 .
Fill out cabinet/slot identification labels on each cabinet and reinstall covers on the cabinets.
(The top cover should be installed on the top cabinet.)
H
C