Toshiba Strata CT, Инструкция по установке и обслуживанию

Страница: 187 / 385

Station Apparatus
Strata CT I&M Manual October 2000
5-31
Attendant Console Load Share Programming
Program 81~89: Assigns Exchange lines to share the incoming call load between consoles.
(Tie lines load share on Dial “0” calls only, without the use of Programs 81~89.) All
incoming Exchange lines (including DDI lines) to be distributed between two or more
Attendant Consoles should be assigned to ring each console in Programs 81~89.
Note Delay ring assignments do not apply to DDI lines.
Programs 71 and 72: Used to provide the assignment of DDI calls. Program 71 assigns the
dialled number to ring at different locations during each Night Mode (Day, Day2, Night).
DDI tags can be added for personalised identification of calls. Program 72 provides external
forwarding of calls listed in Program 71.
Program *17: Assigns each Exchange line to an attendant console as the DDI line intercept
position as required. (Intercept calls do not load share.)
Attendant Console Load Share Programming Example
The user’s company DDI line [DN] is 583-3700; this number and other loop start lines should
ring in a load sharing manner to each of the Company’s two Attendant Consoles in the Day,
Day 2, and Night modes.
Attendant consoles one and two are connected to RATU ports 024 and 025 respectively and
should load share 583-3700 calls and other Exchange line calls. Program the CT as shown
below:
◆
In Programs 81, 84, and 87, assign all Exchange and DDI lines to ring ports 024 and
025.
◆
In Program *81, *84 and *87, assign all Exchange lines to flash the [PDN] of port 024.
◆
In Program 71, assign digits 3700 to port 024, and assign any other selected DDI
extension number(s) to port 025–note that when the DDI extension number assigned to
either console is dialled, calls will load share between consoles.
◆
Port 024 is assigned as a secondary DN (SDN) on the console in Port 025.
◆
In Program 39 assign Port 024 as an SDN on Port 025.
H
C