Toshiba STRATA CIX, Руководство по установке

Страница: 24 / 38

Software Installation
Strata CIX Database Programming
2-12
Strata CIX PC Attendant Console Installation 06/09
Make Station Assignments on CIX
This procedure is for programming a digital station as the attendant console speech path. If you
are setting up an IP attendant console (and do not want a digital station option) skip to
“IP Station
Assignment” on page 2-13 .
1. Digital Station Assignment:
a. Select Station > Station Assignments (Program 200), specify the Prime DN for this
particular Attendant Console. The number entered here is the DN used to reach this
specific console.
Do not use 0 as the Prime DN.
Dial 0 is set in “Create Dial 0
Destination” on page 18 .
Do not assign the Attendant Console PDN to another DKT
or station.
b. Enter data for the FBs listed below:
p
01 – Specifies the equipment number (shelf/slot/port) required for assigning a new DN to
the system. Set the CIX Attendant Console DN to the BDKU\BDKS or BWDKU port
(required).
p
02 – Select DKT Station type (required).
p
03 – Select Extension (not Voice Mail).
p
04 – Toshiba recommends entering COS 10 at the following three prompts:
“COS DAY1=
10
”, “COS DAY2=
10
” and “COS Night=
10
” (preferred).
p
11 – Select Dial Tone - selects Dial Tone as the tone heard after LCR access codes are
dialed.
2. Make DKT Data Assignments on CIX
a. Select Station > Station Assignments > DKT Tab (Program 204), enter the Prime DN for
this particular Attendant Console.
3. Enter data listed below:
p
01 – Assign the Station Type as “Attendant” (required).
p
02 – Select
3
to assign the key strip assignments for the Attendant Console (required).
p
05 – Select Tone First signaling (required).
Required Feature Settings
FB Description Setting
01
PDN Equipment Number
-Specifies the equipment number (shelf/
slot/port) required for assigning a new DN to the system.
xxyyzz
02
Station Type -
to assign the DKT Station type DKT
03 Circuit Type -
assign Extension attributes to ports
Extension
04
COS Day1/Day2/Night -
Toshiba recommends entering COS 10
at the following three prompts: “COS DAY1=
10
”, “COS
DAY2=
10
” and “COS Night=
10
(as per programmed in Prog 103)
10/10/10
11
Dialing Progress Tone -
assign Dial Tone as the type of tone
heard after LCR access codes are dialed
Dial Tone
All other FBs may be set according to the customer’s preference