Toshiba Strata CIX DKT2404-UDR200, Руководство по эксплуатации

Страница: 15 / 22

DKT2404-UDR200 DECT Repeater
INSTALLING THE REPEATER
DKT2404-UDR200 Repeater 12/10
TOSHIBA
9 of 16
• Make sure the location is close enough to a standard 120 V AC power
outlet for the power cord to reach the repeater. Never install electrical
cords across traffic areas where they cause a trip hazard. If the cords
become damaged, they may create fire or electrical hazards.
• Allow at least 35 feet between repeaters. When installing repeaters
across multiple floors allow at least 35 feet vertically.
• Avoid sources of electrical interference, such as hi-fi systems, office
equipment or microwave ovens.
• Avoid heat sources and direct sunlight.
• Avoid things that can interfere with radio signals, such as metal
doors, thick walls, niches and cupboards.
Test The Location Plug the AC adapter into the repeater, then hold the repeater in the place
where you plan to mount it. The LED should remain on and steady,
indicating that the repeater has a good signal from the base. If the LED
flashes, the repeater is not getting a good signal. The repeater may be
too far away from the base, there may be interference from electronic
devices, or the signal might be blocked by thick walls or metal objects. Try
moving the repeater to another location.
Installation 1. Hold the repeater in its final location, and mark the center of the top
edge.
2. From the edge mark, measure down about 1½ inches (approximately
38 mm), and mark the screw location.
3. At the screw location, use a 3⁄16 inch (4.8 mm) drill bit to make a pilot
hole approximately 1 inch (25.5 mm) deep.
4. Place the wall anchor into the pilot hole and tap it gently with a
hammer until the anchor is flush with the wall.
5. Insert the mounting screw into the anchor, leaving approximately 1/4
inch (6.4 mm) of space between the screw head and the wall.
6. Plug the AC power adapter cable into the repeater.
7. Put the repeater over the screw head and slide it down into place.
8. Plug the AC adapter to a 120 V AC power outlet.