Toshiba Strata CIX DKT2404-UDR200, Руководство по эксплуатации

Страница: 13 / 22

DKT2404-UDR200 DECT Repeater
MAP BASE STATION COVERAGE
DKT2404-UDR200 Repeater 12/10
TOSHIBA
7 of 16
The repeater is now registered to this base and is ready to use. You can
safely disconnect the power. The repeater remains registered even if you
disconnect the AC adapter or there is a power failure. Move the repeater
to the selected location, the repeater will stay registered to the base.
Registering Multiple
Repeaters
Use this procedure to register more than one repeater to a base station.
1. Plug in the power supply to the repeater.
2. Register this repeater to the base station using the registration steps
above.
3. Disconnect the power supply from the repeater.
4. Perform 1 ~ 3 for each repeater for this base station.
5. Physically install the repeaters. As the power supply is connected to
each repeater the Link LED should remain lit.
UDR100 and UDR200 repeaters can be combined in a ‘star’
configuration. Refer to
Figure 3 on Page 4 .
Figure 7 – Both Types in Star Configuration
Do not mix UDR100 and UDR200 repeaters in a ‘daisy-chain’
configuration.
Figure 8 – Do Not Mix Repeater Types in Daisy Chain
MAP BASE STATION
COVERAGE Use this process to map the base station coverage area.
1. Stand near the base and make a call.
2. Continue the call, and carry the handset away from the base.
3. Make a note where you start to hear noise on the line, which indicates
the signal is getting weaker. Refer to
Figure 9 on Page 8 .