Preparation
11
SETTING UP THE BASE UNIT (WALL MOUNTING)
MOUNTING ON A STANDARD WALL PLATE:
Insert the bracket’s tabs into the base’s lower
tab slots, then press down on the top of the
bracket to snap it into the clip slots.
• Route the cords through the guides.
• Place the base unit on the posts of the
wall plate and push down until it is firmly seated.
NOTES:
• Do not use any outlet controlled by a wall switch.
• If you don’t have a standard wall plate, cut out the template on this page and
use it to position two screws (minimum length of 1
3
/
8
inches) into the wall
with the heads protruding about
1
/
4
inch.
INSTALLATION
Raise the antenna.
Flip the hook tab over
so the tab holds the
handset.
Single-Line
Telephone Jack
(RJ11C)
Power Outlet
(AC 120 V, 60 Hz)
AC Adaptor
Wall mount template
IMPORTANT:
Before mounting, select a wall area of sufficient
strength. If mounting on wallboard or in an area
of questionable strength, locate a stud for
maximum support of your telephone.
Avoid electrical cables, pipes, or other items
behind the mounting location that could cause a
hazard.
CUT
CUT
•
•
SG-1991.qxd 7/4/1 7:29 PM Page 11
