AI C
ENTRAL
R
EMOTE
C
ONTROLLER
– 9 –
U
NIT
S
ETTING
P
ROCEDURE
1
MONITOR/SET Button
Select the setting mode by pushing this button. SET
will begin to flash on the display.
2
SINGLE SELECT / SELECT ALL Buttons
Select the unit(s) whose settings require modifica-
tion by pressing these buttons.
3
MODE Button
Select the required mode by pressing this button.
FAN ONLY
→
COOL
→
HEAT
→
AUTO
4
FAN Button
Select the required fan speed by pressing this
button.
AUTO
→
HIGH
→
MED
→
LOW
5
TEMP ADJUST Buttons
▼▲
These keys are used to set the required room
temperatures (18-29 ˚C).
●
In the AUTO mode the fan speed changes
according to the room temperature.
6
LOUVER Button
If the unit has a motor driven louver it can be
switched on and LOUVER will be displayed.
7
ON/OFF Button
When this key is pressed the selected air
conditioner will be switched on or off when the set
button is pressed.
8
To register changes to the operating conditions
of the air conditioners press the MONITOR/SET
Button.
The display changes from set to monitor.
●
If the operation of the air conditioner is stopped and immediately restarted by pressing the ON/OFF Button,
the air conditioner will not operate for 3 minutes to protect the unit. After the three minutes the unit will be
allowed to start.
Starting of the Heating operation
●
After the pre heat defrost operation that lasts for 3 to 5 minutes with the indoor fans stopped. The fans will
then operate at the set fan speed.
Starting of the Cooling operation
●
The air conditioner will start in the cooling mode after approximately 1 minute.
GB
