AI C
ENTRAL
R
EMOTE
C
ONTROLLER
00
– 8 –
S
INGLE
/G
ROUP
S
ELECTION
P
ROCEDURE
●
If the new settings are not registered by pressing the set key within 15 seconds of the last change the status
of the Central Remote Controller will revert to the monitor mode without changing any settings.
●
If an air conditioner is connected to the Central Remote Controller its number will appear in the connected
unit display. If the unit is in the on state, the number will be underlined.
1
MONITOR/SET Button
Select the setting mode by pushing this button. SET
will begin to flash on the display.
2
SINGLE SELECT Button
Select the unit whose settings require modification
by pressing this button. Each time this button is
pressed the display scrolls through the number of
each connected indoor units.
3
SELECT ALL Button
If all of the air conditioners connected to the Central
Remote Controller require the same setting press
this button and they will be selected: SET ALL will
flash.
4
Indoor unit setting this is explained in detail
on the following page.
5
ON/OFF Button
When this button is pressed the selected air condi-
tioner will be switched on or off.
6
MONITOR/SET Button
The display changes from SET to MONITOR.
To register changes to the operating conditions of
the air conditioners press this Button.
Example
Connected Unit Window
1 2 3 4 5 6 7 8 1 2 3 4 5 6 7 8
9 10 11 12 13 14 15 16 9 10 11 12 13 14 15 16
16 Units Connected but in the
OFF Status
16 Units Connected but in the
ON Status
GB
