Compact 4-way Type
Owner’s Manual
EN
Compact 4-way Type
Owner’s Manual
– 8 –
6
Adjustment of Wind Direction
For best cooling and heating performance, adjust the louvers (adjustment plates of up / down wind direction)
appropriately. Cold air descends and warm air rises, so to heat a room tilt the louvers downward, and to cool a
room tilt them horizontally.
CAUTION
Direct the louvers horizontally for cooling.
If the louvers stay pointed downward when cooling, condensation may form on the discharge port and / then drops from
the louvers.
NOTE
If the louvers stay pointed straight out horizontally when heating, the room temperature may be unevenly
distributed.
• When the air conditioner is not working, the louvers are directed horizontally automatically.
• The louvers are directed horizontally when heating begins, during defrost operation, or during the minimum
operation after reaching the set temperature.
When a swing or louver direction setting is made at this time, the remote controller display varies with the setting,
but the louvers stay pointed straight out horizontally.
When the air conditioner starts heating, the louvers are directed to the set direction.
For cooling (COOL)
Direct the louvers horizontally.
For heating (HEAT)
Direct the louvers downward.
How to set up the louver direction
1
Push
during operation.
The louver direction changes for every push of the
button.
In HEAT operation
Direct the louver (adjustment plate of up / down wind
direction) downward. If directing at horizontally, hot air
may not come to the foot.
In COOL / DRY operation
Direct the louver (adjustment plate of up / down wind
direction) horizontally. If directing it downward, the dew
may form on the surface of the air discharge port and
may drop down.
In FAN operation
Select a desired louver direction.
How to start swinging
1
Push
, set the louver (adjustment plate
of up / down wind direction) direction to the
lowest position, and then push
again.
SWING
is displayed and the up / down louver
direction is automatically selected.
Display during swinging
How to stop swinging
1
Push
at a desired position while the
louver is swinging.
• When
is pushed after that, wind
direction can be set again from the highest
position.
Display when swinging is stopped
In this case, push
again two seconds later.
• In Cool / Dry operation, the louver does not stop
as it directs downward. If stopping the louver as
it directs downward during swing operation, it
stops after moving to the third position from the
highest position.
1
Unit select button
Initial setup
Initial setup
Initial setup
* However, even if
is pushed while the
louver is swinging, the louver position is
displayed as follows and highest position of the
louver may not be selected.
Repeat
Fan / Heat
operation
Cool / Dry
operation
15-EN
16-EN
+00EH99937799_01EN.book Page 8 Thursday, March 31, 2011 10:00 PM
