-14-
ACL
ACL
CLOCK
(Rear bottom of remote controller)
Rear bottom cover
All clear button
Switch for selecting
service mode
CLOCK
Switch for selecting
service mode
2-2-2.
Reverting to Normal Mode
Push the all clear button (ACL) on the rear bottom of the wireless remote control with a tip of pencil for
more than 3 seconds. Make sure the operation mode display, fan speed display, clock display and setting
temperature display are turned on and “
: ” of the clock display is flashing.
2-2-3.
Cautions when carrying out servicing
1)
After completion of servicing, always push the all clear (ACL) button to return the operation mode to the
normal mode.
2)
After completion of servicing by the check code, isolate the power supply and then reconnect to
reset memorized contents of the microcomputer to the initial status.
2-2.
CHECK CODES
The fault codes can be checked by putting the remote controller into service mode, and then checking the LED's
on the receiver according to the table in 2-1-2.
2-2-1. Selecting service mode
Push the button provided under the battery cover of the wireless remote control with a tip of pencil for more than
3 seconds. make sure “
” is showing on the display.
All clear button
Battery cover
