– 77–
FILE NO. SVM-05016
10. PART REPLACEMENT
10-1. Indoor Unit
How to remove the front panel
1) Stop the operation of the air conditioner and turn off
its main power supply.
2) Pull the inlet grille toward you to open it and remove
the inlet grille.
3) Take off the right side of air filter.
4) Pull out the plasma air purifier and remove 4 screws
fixing the front panel before open the horizontal
louver and then remove the front panel from back
How to mount the front panel
1) Mount the front panel with the inverse procedure of
"How to remove the front panel
"
.
2) Push 3 places (right, left and center) of the air
outlet.
3) Check the gap between the front panel and the
back body.
If you operate the air conditioner in cooling or dry
operation without pushing the 3 places, the surface
of the front panel may be covered with frost and
have dewdrops.
Open the horizontal grille right below by hand.
5)
body by pulling it toward you.
Pull the lower side of the front panel toward you
6)
until
it touches the horizontal grille to remove it.
1) Remove the front panel with the procedure
1
.
2) Remove the screw fixing the electrical part box.
3) Remove the drain guide.
4) Remove the connector (5P) for the fan motor and
the connector (6P) for the louver motor from the
microcomputer assembly.
5) Remove the screw for the earth, and pull the
electrical part base toward you to remove it from
the main unit.
6) Pull out the TC sensor from the sensor holder.
1
Front panel
2
Electrical part
assembly
No.
Part name
Procedures
Remarks
When assembling the electrical parts
assembly, make the connecting cable
U-shaped and put it in the drain pan.
(3) Drain guide
(6) TC sensor
(3) Drain guide
(2) screws
(5) screws
5P
6P
(4)
(3)
4-screws
(2)
(2)
(2)
