29-EN
Installation Manual
– 29 –
indoor unit.
1. Remove the air inlet grille.
Open the air inlet grille upward and pull it toward you.
2. Remove the terminal cover and the clamp base.
3. Insert the control wire fully into the control/wired remote controller terminal block and
secure it tightly with screws.
4.
the left of the control/wired remote controller terminal block.
5.
6. Install the clamp base with a screw.
7. Insert the power supply wire fully into the terminal block and secure it tightly with screws.
Tightening torque: 1.2 N·m (0.12 kgf·m)
Secure the earth line with the earth screw.
8. Clamp the power supply wire with the cord clamp.
9.
terminal.
Secure the earth line with the earth screw.
10.
11. Attach the terminal cover, the front panel and the air inlet grille to the indoor unit.
N
L
Control wire
Terminal
block for
control/wired
remote
controller
wiring
Control wire
from the
Connector
Power supply
terminal block
Earth screw for
Cord clamp
Power supply wire
Cord clamp
Power supply wire
CAUTION
Confirm that every wires are stored in the electric parts box without getting caught before attaching the
terminal cover.
