Toshiba IK-TF5P2, Инструкция по эксплуатации

Страница: 34 / 40

34
External Sync 7. 7
7HENUSINGTHEUNITWITHANEXTERNALSYNCSIGNALINPUT($AND6$TO##AND##OFTHE$)')4!,TERMINAL
When the external sync signal is input, the camera automatically switches its sync from the internal sync to the
external sync.
The operation is as shown below, depending on the unit’s status and how external sync signals are input.
Shutter mode HD input 6$INPUT Note
At time of SYNC-NON
RESET mode N N Internal sync mode
Y Y External sync mode
N Y
/NLY6RESETISAPPLIEDDUETO6$INPUT.ORMALLYNOTUSED
Y N ($ISSYNCHRONIZEDTOEXTERNALBUTVIDEOISNOTOUTPUT because
THEREISNO6$INPUT.ORMALLYNOTUSED
At time of SYNC-
RESET mode N
*
)NTERNALSYNCMODE4HEPRESENCEOF6$ISIGNOREDANDAFTERA
specified time after a trigger input, V reset is applied.
Y
*
($ISSYNCHRONIZEDTOEXTERNAL4HEPRESENCEOF6$ISIGNORED
and after a specified time after a trigger input, V reset is applied.
At time of reset restart Y Y ($ISSYNCHRONIZEDTOEXTERNAL6IDEOISOUTPUTDUETO6$INPUT
N Y ($ISSYNCHRONIZEDTOTHEINSIDEOFTHECAMERA6IDEOISOUTPUT
DUETO6$INPUT
*
N 6IDEOISNOTOUTPUTBECAUSETHEREISNO6$INPUT.ORMALLY not
used.
At time of manual
shutter N N Internal sync mode
Y Y External sync mode
Y N
($ISSYNCHRONIZEDTOEXTERNAL.ORMALLYNOTUSED
N Y $ISABLED
*
Either Y or N is permitted.
External sync signal polarity ( 1 )
($TO6PP .EGATIVE
6$TO6PP .EGATIVE
External sync frequency range ( 2 )
%XTERNALSYNCWITH($6$
7ITHIN›ATHORIZONTALSYNCFREQUENCYOFK(Z
Using the unit with external sync signal ( 3 )
When adjusting H (horizontal) phase refer to the item “7.2 (6) (6.1) Adjusting horizontal phase”.
H (horizontal) phase adjustment (3. 1)
Observe the external sync signal and the LVAL signal output waveform
of the unit with a dual trace oscilloscope, and adjust H phase so that
the H phases match. External
Sync. signal
Match
the phase.
LVAL signal
output