Toshiba GX7R ASD, Быстрый старт

Страница: 40 / 85

32 GX7R ASD Quick Start Guide
System Operation
Start Up
Upon initial system powerup, the GX7R ASD runs a system initialization. During the initilization, the
system checks several subsystems for functionality.
These include:
• Precharge Cycle functionality,
• ST -to- CC connection completion at the regeneration terminal board,
• The Boost Voltage function, and
• Bus voltage stabilization at 800 volts.
These checks take ten seconds to complete. Should a subsystem fail during the initialization, a Front-End
Fault will be incurred.
Note: The EOI displays OFF until the CC -to- ST connection is completed at the regeneration
terminal board.
Upon completion, the Startup Wizard begins.
Startup Wizard
The Startup Wizard launches without user intervention and may be run to assist the user with the initial
configuration of the input power settings and the output parameters of the GX7R ASD .
The GX7R ASD may also be setup by directly accessing each of the individual parameters (see the GX7R
ASD Install and Op Manual ). See the section titled Default Setting Changes on pg. 33 for more
information on changing the parameter settings.
The Startup Wizard is run from the Program (menu)

Startup Wizard .
The Startup Wizard querys the user for the following information:
Note: After each entry, Finish may be clicked to load the Startup Wizard settings and exit.
1. Run now? (if selected continue on to step #2)/ Run next time at power up? (if selected go to
Program screen)/ Manually configure? (if selected click Finish

Frequency Command screen).
2. The Voltage and Frequency Rating of the Motor .
3. The Upper Limit Frequency .
4. The Lower Limit Frequency .
5. Adjust Accel/Decel Automatically? (if Yes , continue from step 8 ).
6. The Acceleration Time .
7. The Deceleration Time .
8. The Volts Per Hertz Setting .
9. The Motor Current Rating .
10. The Command Source .
11. The Frequency Command Source .
Click Finish to load the settings of the Startup Wizard into the ASD. Further application-specific
settings may be required.
See the section titled
Startup Wizard Requirements on pg. 53 for additional information on the Startup
Wizard .