Toshiba e-STUDIO165, Руководство по обслуживанию

Страница: 235 / 313

© 2006 - 2008 TOSHIBA TEC CORPORATION All rights reserved e-STUDIO165/167/205/207/237
TROUBLESHOOTING
5 - 17
5
5.1.5 Drive system related service call
[C01] Main motor is abnormal
Is the main motor working? (Perform the output check in the test mode: 04-101/151)
l
l
l
l
l
l
l
l
NO 1) Check if the connector CN1 of the main motor is disconnected.
2) Check if the connector CN16 on the MAIN board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor patterns on the main motor board and MAIN
board are short circuited or open circuited.
5) Replace the main motor.
6) Replace the MAIN board.
YES
Is the LED on the main motor board lit without flickering?
l
l
l
l
l
l
NO 1) Check if the connector pins are disconnected and the harnesses are
open circuited.
2) Check if the conductor patterns on the main motor board and MAIN
board are short circuited or open circuited.
3) Replace the main motor.
4) Replace the MAIN board.
YES
1) Check if the PLL lock signal CN305-B8 output from the MAIN board is always level “L”.
2) Check if the voltage supplied to the CPU input terminal IC24-12 is always “L”.
3) Replace the MAIN board.
[C07] Exit motor IC overcurrent detection error
(only for e-STUDIO165/205)
Is the exit motor working?
l
l
l
l
l
l
l
l
NO 1) Check if the connector of the exit motor is disconnected.
2) Check if the connector CN245 on the PFU board is disconnected.
3) Check if the connector pins are disconnected and the harnesses are
open circuited.
4) Check if the conductor patterns on the PFC board are short circuited
or open circuited.
5) Replace the exit motor.
6) Replace the PFC board.
YES
1) Check if the voltage supplied to the driver IC terminal IC5-8 on the PFC board is always
at level "H".
2) Replace the PFC board.
[C08] ADU motor IC overcurrent detection error
07/06