Toshiba DB-EA4D, Руководство пользователя

Страница: 43 / 80

5. PRINTER SETUP
ENGLISH VERSION
5.7 Sensor Calibration
E5-15
5.7.3 SENSOR CALIBRATION WITH LABEL PAPER
This mode performs Sensor level adjustment test with label paper.
Sequence:
1. Select “Sensor Calibration” in main menu of
Menu Mode,
And Press [FEED] key shortly.
A message appears on the LCD, as shown below.
2. Select “Calibration with Label Paper”.
And press [FEED] key shortly.
A message appears on the LCD, as shown below.
3. Remove paper and roll paper.
4.
Press [
FEED
] Key shortly.
A message appears shortly
on the LCD, as shown below.
5. After the calibration with no paper was performed, a message appears on the LCD as shown
below.
6. Set lable paper in the printer.
7. And insert the paper into the printer without thermal print head unit open.
8. Press [
FEED]
Key shortly.
Starts loading and feeding a paper, and starts the calibration with label paper.
A message appears on the LCD as shown below.
9. Depends on calibration the result, a message appears on the LCD as shown below.In case of
succeeded sensor calibration
10. In case of failed sensor calibration
11. Press and hold [
FEED]
Key for three seconds to exit Menu Mode.
Calibration
Performing…
Calibration
Succeeded
Failed 12345
- - x - -
1: Paper End Sensor 2: Exit Sensor
3: TOF Sensor
4: BM Sensor 5: Label Sensor
- : No Error X : Failure
Remove paper
Press FEED key
Set BM paper
Press FEED key
Calibration
Performing…
NOTE:
1.
Press [MENU] key shortly,
it shifts the selection mode as
arrow.
2. Press [PAUSE] key shortly,
it shifts the selection mode as
arrow.
3. Press [FEED] key shortly,
Enter menu or save setting value
Firmware Version, CRC
Communication Interface
Printer Configuration
Printer Adjustment
Printer Test Modes
Sensor Calibration
Menu Mode Exit
Main Menu
Calibration with BM paper
Calibration with White Paper
Calibration with Label Paper
Calibration with Perforation Pap.
Return to Rrev. Layer
Function Menu
①
Calibration with
BM Paper
②