Toshiba Carrier RAV-SP180KRT-UL, Руководство по установке

Страница: 27 / 88

High-Wall Type
Installation Manual
– 26 –
Toshiba
EN
„
Manual address setup procedure
(Procedure example 1)
While the operation stops, change the setup.
(Be sure to stop the operation of the unit.)
Procedure
1
Push simultaneously + + buttons for 4
seconds or more. After a while, the display part
flashes as shown below. Check the displayed
CODE No. is [
10 ].
• When the CODE No. is other than [ 10 ], push
button to erase the display and repeat procedure
from the first step.
(After pushing
button, operation of the
remote controller is not accepted for
approx. 1 minute.)
(For a group control, No. of the firstly displayed
indoor unit becomes the header unit.)
Procedure
2
Every pushing button, the indoor UNIT No.
in the group control is displayed in order. Select the
indoor unit of which setup is changed.
In this time, the position of the indoor unit of which
setup is changed can be confirmed because fan
and louver of the selected indoor unit operate.
Procedure
3
1. Using temp. setup / buttons,
specify CODE No. [ 12 ].
(CODE No. [ 12 ]: Line address)
2. Using timer time / buttons, change
the line address from [ 3 ] to [ 2 ].
3. Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
Procedure
4
1. Using temp. setup / buttons,
specify CODE No. [ 13 ].
(CODE No. [ 13 ]: Indoor address)
2. Using timer time / buttons, change
the indoor address from [ 3 ] to [ 2 ].
3. Push button.
In this time, the setup finishes when the
display changes from flashing to lighting.
2,6 1
7
3
-1,
4
-1,
5
-1,
7
3
-3,
4
-3,
3
-2,
4
-2,
5
-2
5
-3,
(* Display changes according to
the model No. of indoor unit.)
Indoor UNIT No. before setup change is displayed.
Indoor UNIT No. before setup change is displayed.
26-EN
+001111052201_00Ta.book Page 26 Friday, November 20, 2009 11:45 AM